Continuous & Cutting

Overshot

CONTINUOUS TUBING OVERSHOT

The continuous tubing overshot is used to retrieve coiled tubing or threaded pipe. This overshot is a non-releasable tool designed to swallow large sections without dulling grapples.

Key features

  • Wide Catch Range
  • Swallow Large Sections of Tubing
  • Coiled Tubing or Threaded Pipe
CONTINUOUS TUBING OVERSHOT

CUTTING OVERSHOT

The Cutting Overshot is used to cut and retrieve coiled tubing that has been parted, stuck or abandoned in the well bore. Once the appropriate overpull is reached screws are sheared causing the blades to sever the coiled tubing. A clean fishing neck is left looking up.

Key features

  • Retrieve Cut Segment
  • Reduced Overpull and Necking of Coil
  • Leaves Clean Cut
  • Coiled Tubing or Threaded Pipe
CUTTING OVERSHOT

Specs

CONTINUOUS TUBING OVERSHOT

o.dI.D.LENGTH OVERPULLTORQUECATCH RANGECONNECTION
in mmin mmft mlbs kgft-lbs Nmin
1.86 47.21.31 33.42.05 0.6225,040 11,3581,010 1,3691” to 1-1/4” 1-1/4” CS
2.06 52.31.31 33.42.45 0.7552,000 23,587 800 1,0851” to 1-1/4”1-1/4” CS
2.70 68.61.81 46.12.46 0.7549,600 22,4982,250 3,0511” to 1-3/4”2-3/8” CS
3.13 79.31.88 47.82.83 0.8667,200 30,4812,950 4,0001” to 1-3/4”2-3/8” CS
3.38 85.72.13 53.92.64 0.8072,800 33,0224,560 6,1821” to 2” 2-7/8” CS

Specs

CUTTING OVERSHOT

o.dI.D.LENGTH OVERPULLTORQUECATCH RANGECONNECTION
in mmin mmft mlbs kgft-lbs Nmin
2.06 52.41.31 33.41.96 0.6052,000 23,5871,360 1,8441” to 1-1/4”1-1/2” CS
2.50 63.51.56 39.72.98 0.9159,200 26,853 2,440 3,3081-1/2”2-1/16” CS
2.70 68.61.81 46.13.25 0.9949,600 22,4982,250 3,0511-1/4” to 1-3/4” 2-3/8” CS
3.38 85.72.13 53.92.90 0.8872,800 33,0224,580 6,2101-3/4” to 2”2-7/8” CS

Featured Products

A-10
A-10
XRV
XRV
Abrasive Release Connector
Abrasive Release Connector